Welcome to the PearPC Configuration File Generator

NOW WORKS WITH VERSION .2 (comming soon, saving settings in Cookies)
All of the default values are thrown in below, at the bear minmum,
you must configure your IO devices.
If you do not know what something is, it would be a good idea to leave it alone.
Resolution

Choose the resolution you want to use.



Redraw Interval (in ms)
Must be between 1 and 999

If you set this higher, PearPC will spend less time doing redraws (and so run faster)
but feel less responsive. You should adjust this to your computer speed and personal
preference.

Redraw interval (in ms):



Boot Method

Choosing "Auto" will boot the first bootable partition
Choosing "Select" will show a list of bootable partion
Choosing "force" will boot the local file prom_loadfile (force is currently not implimented)

Boot method:
Auto
Select



Verbose Mode: If you're booting Darwin, set this on. If you're booting OS X, turn it off.

On
Off
Single User Mode (Use to Partition disks without Darwin)




I/O Devices


Master Device




Is there a Master device?
Yes
No


Image File Location:

(NOTE: This will be where your blank HDD file is if you are using a hard drive for this)




Type: Hard Drive
CD-ROM Drive

Slave Device




Is there a Slave device?
Yes
No


Image File Location:

(NOTE: This will be where your CD image file is if you are using a CD-ROM for this)




Type: Hard Drive
CD-ROM Drive



Network Options



Network Installed:
Choose A Network Card: RealTek-8139 3-Com 90x


Yes
No


Network MAC Address:

USB

USB Installed?
Yes
No




NVRAM File (EVIL SETTING!!! DON'T CHANGE UNLESS YOU KNOW WHAT YOU ARE DOING!!!)

Location of the NVRAM File





Main Memory (EVIL SETTING!!! DON'T CHANGE UNLESS YOU KNOW WHAT YOU ARE DOING!!!)




CPU Config (EVIL SETTING!!! DON'T CHANGE UNLESS YOU KNOW WHAT YOU ARE DOING!!!)










If you found this useful, please donate a dollar or two. I'm just a poor student, and any amount would help. Thanks.

NOTE: I take no responsibility for anything.